Replacing the exhaust fan

Step 1:

Unplug the USB and power leads from the Emblaser 2.

Air_Assist_-_Installation_guide-01-01.png

 

 

Step 2:

Remove the 5 screws holding the rear electronics pod in place

 

Micro_Board_Replacement-01.png 

 

Micro_Board_Replacement-02.png

 

 

 

Step 3:

Unplug the exhaust fan connector from the controller board.

Carefully remove the old fan. Please note that the fan is attached to the electronics pod with a piece of double-sided tape and will need to be pulled away. Carefully remove any remaining double-sided tape from the electronics pod.

 

Exhaust_Fan_replacement-03.png

 

 

Step 4:

Apply the supplied piece of double-sided tape to the back of the electronics pod.

 

Exhaust_Fan_replacementa.png

 

 

Step 5:

Install the new fan ensuring it is firmly attached to the double-sided tape. Plug in the connector as shown.

Exhaust_Fan_replacement-03.png

 

Step 6:

Re-attach the electronics  pod to your machine.

 

Micro_Board_Replacement-06.png

Have more questions? Submit a request

Comments

Article is closed for comments.