Problem:
It is not possible to 'enable' the laser, with the lid closed.
Cause:
A heavy knock received during the shipping may cause the lid and interlocks to become out of alignment.
Solution:
Please follow the following steps.
Step 1:
First, check to make sure your Emblaser 2 is sitting on a flat surface. Make sure each of the Emblaser feet are sitting on the same surface.
Step 2:
Take a 6cm strip of masking tape and cover each of the interlock PCB contacts in the left and right lid handle.
Step 3:
Use a pencil to mark the top of each of the interlock pins.
Step 4:
Close the lid and press down onto each corner.
This will leave a small mark on the masking tape, where the pins have made contact.
Step 5:
You can now use the two situations below to adjust your lid and interlocks.
SITUATION 1
If your marks are as the image above, place pressure on your Emblaser chassis as shown in the image below.
SITUATION 2
If your marks are as the image above, place pressure on your Emblaser chassis as shown in the image below.
Step 6:
Remove the masking tape and wipe any residue off the corner interlock pins, then check for correct 'enabling'.
Comments
Article is closed for comments.