Replace Emblaser 2 SD Card (Rev1.0)

If you experience issues with your onboard SD card, and are instructed by Darkly Labs or an authorised reseller to replace it, please follow the following steps:

 

Step 1:

Remove the 5 screws holding the rear electronics pod in place.

Be careful to not disturb any wiring or connectors as the rear pod comes free.

SD_card_-_Replace-01.png

 

Step 2:

Carefully remove the 4 screws holding the electronics PCB in place.

This will let you gain access to the SD card.

SD_card_-_Replace-02.png

 

Step 3:

Remove the SD card and replace it with your new card.

 

SD_card_-_Replace-03.png

 

Step 4:

Follow the steps in reverse to reassemble your electronics pod.

Important: Please be careful that no cabling becomes trapped between the read pod and the enclosure sides.

 

Have more questions? Submit a request

Comments

Article is closed for comments.