How to align lid.

 

Step 1:

First, check to make sure your Emblaser 2 is sitting on a flat surface. Interlock_Allignment-01.png

 

Step 2:

Take a 6cm strip of masking tape and cover each of the interlock PCB contacts in the left and right lid handle.

Interlock_Allignment-03.png

 

Step 3:

Use a pencil or whiteboard marker to mark the top of each of the interlock pins.

Interlock_Allignment-02.png

 

Step 4:

Close the lid and press down on each handle.

The pins will leave a small mark on the masking tape.

 

Step 5:

Compare the marks on your masking tape to the conditions below.

 

Condition 1

Interlock_Allignment-04.png

If your marks are the same as image above (skewed to the right), apply pressure to your Emblaser2 chassis as shown in the image below. 

Interlock_Allignment-07.png

 

SITUATION 2

Interlock_Allignment-05.png

If your marks are the same as image above (skewed to the left), apply pressure to your Emblaser2 chassis as shown in the image below. 

Interlock_Allignment-06.png

 

Step 6:

Remove the masking tape from the handles and thoroughly clean the mark from the pins; your Emblaser2 should be correctly enabling. 

 

Have more questions? Submit a request

Comments

Article is closed for comments.