How to clean the Laser Driver PCB.

You may be able to skip this process if you have access to compressed air; a gentle jet of air directed under the cover should remove most debris from the PCB.

 

STEP 01.

Remove the two screws holding the laser carriage cover.

 

Take note of cable positions when the cover is removed. This will help when putting everything back together.

 

 STEP 02.

Use the small brush to gently remove any build up of debris on the Laser Driver PCB.

Gently brush the components under the fan and the small component at the bottom of the PCB clean of debris.

STEP_02b.jpg

 

 

STEP 03.

Reattach the laser cover. Make sure all cables have been routed correctly.

 

 

 

Have more questions? Submit a request

Comments

Article is closed for comments.