The Emblaser 2 & Core are designed to detect situations that may be dangerous or cause damage to your machine.
The Emblaser stops cutting, moves over to the top left side and emits a constant beep.
This is most commonly caused by the machine detecting an over-temperature situation.
This can be caused by one of the following situations:
- 1: Excessive debris has built up on the Laser driver PCB or Laser Driver PCB fan and it is not being cooled adequately.
- 2: Material has ignited inside the workspace and raised the workspace temperature above the detection threshold.
Follow the steps in this article to clean your Laser Driver PCB: LINK
If the problem continues to happen, please follow these steps and contact firstname.lastname@example.org with the results: