New post
-
E Core on Windows 70 votes 2 comments
-
Only one move with "Fire" activated, then nothing Completed0 votes 6 comments
-
slight shift0 votes 0 comments
-
Light burn trial code vs code in my kit0 votes 2 comments
-
Is the Emblaser Core on backorder and is there a known ship date?0 votes 2 comments
-
Changing Speed from mm/m To mm/Sec0 votes 2 comments
-
Core focus too low0 votes 7 comments
-
Safe to cut a fridge magnet?0 votes 4 comments
-
Emblaser Core power compared to Emblaser 10 votes 1 comment
-
not homing0 votes 0 comments
-
E2 cutting issues - bad results, or hopes too high?0 votes 5 comments
-
Device Not Recognised0 votes 0 comments
-
Re-installing Cut2D Laser on new PC0 votes 0 comments
-
Contact film0 votes 3 comments
-
Reduced laser power with Cut 2D Laser version 8.5 later0 votes 0 comments
-
How to use super lube?0 votes 1 comment
-
Vertical Lines0 votes 2 comments
-
Cutting plywood0 votes 4 comments
-
Emblaser 2 Firmware update issues [126]0 votes 1 comment
-
"CUT/CUTTING" SAME AS "LINE" IN MODE MENU??0 votes 3 comments
-
New Emblaser 20 votes 1 comment
-
Shift in cutline - Help!0 votes 2 comments
-
Loud constant beep after first turn on0 votes 5 comments
-
Thick Paper - Getting Yellowish Scorch/Burn Marks1 vote 4 comments
-
Cannot connect Network0 votes 1 comment
-
Keeps loosing connecion with Emblaser 20 votes 1 comment
-
Runtime Error C++ Win 70 votes 3 comments
-
Help My emblaser 2 is having a meltdown!0 votes 2 comments
-
E Core not moving as expected0 votes 5 comments