Emblaser 2 & Core
New post-
E Core on Windows 70 votes 2 comments
-
slight shift0 votes 0 comments
-
Is the Emblaser Core on backorder and is there a known ship date?0 votes 2 comments
-
Changing Speed from mm/m To mm/Sec0 votes 2 comments
-
Core focus too low0 votes 7 comments
-
Safe to cut a fridge magnet?0 votes 4 comments
-
Emblaser Core power compared to Emblaser 10 votes 1 comment
-
E2 cutting issues - bad results, or hopes too high?0 votes 5 comments
-
Device Not Recognised0 votes 0 comments
-
Contact film0 votes 3 comments
-
How to use super lube?0 votes 1 comment
-
Vertical Lines0 votes 2 comments
-
Cutting plywood0 votes 4 comments
-
Emblaser 2 Firmware update issues [126]0 votes 1 comment
-
"CUT/CUTTING" SAME AS "LINE" IN MODE MENU??0 votes 3 comments
-
New Emblaser 20 votes 1 comment
-
Shift in cutline - Help!0 votes 2 comments
-
Loud constant beep after first turn on0 votes 5 comments
-
Thick Paper - Getting Yellowish Scorch/Burn Marks1 vote 4 comments
-
Cannot connect Network0 votes 1 comment
-
Help My emblaser 2 is having a meltdown!0 votes 2 comments
-
E Core not moving as expected0 votes 5 comments
-
WTF Connection and other issues0 votes 5 comments
-
"Return To Finish Position" will not turn off0 votes 1 comment
-
Having communication problems with laser.1 vote 1 comment
-
ECore Power Adapter0 votes 1 comment
-
New Core owner - initial impressions, feedback, and questions0 votes 2 comments
-
E2 alarm lock error0 votes 7 comments
-
Re: Noise0 votes 2 comments